Being the brain of any automated system, these control boards carrefully produced to the smallest detail, provide the perfect control for every automations.

MC50

This 230V monophasic electronic control board is standard through all the barriers range, OL1500 and OL2000 sliding motors and in the KVM105 shaft traction motor. With built-in receiver, stores 99 codes (rolling code) in memory for complete opening and 99 more for pedestrian opening. This control board can also be used on motors up to 1000W.

MC61

24 V DC Control board with programming through display, incorporated receiver, obstacle detection, limit-switches, automatic course programming, time regulation for soft stop, maximum consumption for 1A motors, lock management, 23 Rolling Code memories for 433.92Hz.

MC52

Control board with new features that makes it more complete than the MC2. In addition to all the features of the MC2 control board, it has even more:

Display with selectors for programming;
RGB output or port status;
Selection of cell parameters. Program these to act in the opening or in the closing, to invert completely or if it only inverts 2 sec, etc.;
Possibility to delete a specific command without having to delete all others;
Maneuver counter.

MC1

230V single-phase control board, for 1 leaf sliding gates with built-in receiver, memory for up to 215 different “Rolling Code” codes.
It has other functions like soft stop and soft start, electronic force limiter.

MC111SC

Control board with built-in frequency converter for three-phase motors up to 1500W, power supply at 230V AC, course with slowdown programming, limit-switches, 230V flashing lamp output, normal and slowdown movement amperometric detection, electric brake connection possibility.

MC2

Control board for two 230V motors, with built-in receiver inside a big box;
Slowdown when closing and opening;
Individual slowdown control for each leaf;
Pedestrian opening where you can choose desired opening angle;
Output for electric lock;
Maximum strength at the start;

MC4SP IP

Control board for TUB / ROLLING motors:
Stores up to 15 different codes;
For motors up to 350W of power;
Wall switch connection, ascent and descent separated contact;
Allows to centralize the control of blinds, memorizing local and total code;

MC70

Control board for TUB / Rolling motors; 230V AC power Supply; 1 230V motor output up to 500W; Control possibility via push-button; Allows centralization through switches; Stores up to 15 different codes Rolling code; Possibility to program three channels,up / stop / down or just one step-by-step channel.

MC7

Control board to control 1 motor with a maximum of 500W 230V;
Compatible with WIWEATHER sensor and works as cinema kit – when turning on the projector, the canvas drop automatically;

MC230

Control compatible board with all the security devices, with built-in receiver, separate open/close start buttons, soft start/stop, open and close strength individually programable, emergency cut-off. 230V monophasic control board in industrial box)

MC400

Control compatible board with all the security devices, with built-in receiver, separate open/close start buttons, soft start/stop, open and close strength individually programable, emergency cut-off. 400V three-phase control board in industrial box.

MC111PR

Control board with built-in frequency converter for three-phase motors up to 1500W, power supply at 230V AC, course with slowdown programming, limit-switches, 230V flashing lamp output, normal and slowdown movement amperometric detection, electric brake connection possibility;

MC65

Developed for the TUB motors range, the MC65, when applied on awnings, allow the automatic tensioning of the fabric, so that it remains always in the correct position and without ripples.